Hinges GN 237.1 have a design that makes them perfect for attaching panels, such as of glass or plastic.
For installation, set the centering aid d3 of the hinge against an appropriately-sized hole in the panel. The hinge is attached with a carriage bolt DIN 603, which is fastened on the back side of the panel with a nut, a step washer and a flat washer.
The step washer and flat washer are included.
Specification
Plastic (Polyamide PA-HP)
Glass fiber reinforced
Temperature resistant up to 70 °C
Black, matte finish
Pin
Stainless steel AISI 303
Step washer
Rubber NBR
Hardness 70 Shore A
FDA compliant plastic granulate
Flat washer
Stainless steel
RoHS
Hide technical drawing
Article options / Table
Type
AG
2x bores for countersunk screws / 1x bore for panels
If this article is new in our product range, it may happen that details concerning weight are as yet not listed. If you do need weight details, please contact our Sales Department! Phone+49 7723 6507 - 0
RoHS: Yes
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances).
Customs tariff number
39263000
Please note our order discounts.
With a total value (net) per order: from 175,00 € -> 10 % discount from 275,00 € -> 20 % discount from 375,00 € -> 30 % discount
Surcharge for small volume purchases: -> 15,00 Euro for value of goods less than 25,00 € -> 10,00 Euro for value of goods from 25,00 to 49,99 €
ELESA original design 
