Product description
Toggle clamps GN 810.3 are latched in both end positions. In the clamped position, this prevents unintentional opening or opening caused by vibrations; and in the open position, it prevents self-closing of the toggle clamp, such as due to an extended clamping arm. The latching can be disabled with a single hand to allow for opening / closing.
They work according to the toggle principle: lever and clamping bar move in the same direction. In the clamped position the operating lever is in its vertical position.
Toggle clamps in the U-bar version with two flanged washers (type AL) can accommodate an application specific clamping screw. A clamping screw with neoprene rubber tip is also included for type CL.
Type EL version can be utilized by welding the clasp which can then accommodate an application specific hold-down fastener component.
Specification
Tensioning mechanism
Steel
- Sheet metal parts
Case-hardened steel C10, zinc plated, blue passivated - Bearing pins tempered
- Bearing rivets case-hardened
- Moving parts lubricated with special grease
Handle
Plastic
Red, oil resistant
Flanged washers GN 898 for type AL / CL
Steel
Zinc plated, blue passivated
Clasp for type EL
Steel
Zinc plated, blue passivated
Clamping screws GN 708.1 for type CL
- Steel, zinc plated, blue passivated
- Rubber tip
- 85 Shore A
- Type A (flat pressure area)
RoHS
Accessory
Holders for Clamping Screws GN 801 (für Form AL)
Clamping Arm Extenders GN 801.1 (für Form AL)
Clamping Arm Extenders GN 801.2 (für Form AL)
Clamping Arm Extenders GN 809.1 (for type EL)
